| MRC |
Requirement Statement |
Characteristics |
| ABXF |
SHAFT LENGTH |
0.062 INCHES NOMINAL |
| CRSX |
ACTUATOR TRAVEL CONTROL FEATURE |
CLUTCH |
| AKPV |
MOUNTING FACILITY QUANTITY |
2 |
| ADAT |
BODY WIDTH |
0.250 INCHES NOMINAL |
| AGTP |
LATERAL DISTANCE BETWEEN MOUNTING HOLE CENTERS |
1.000 INCHES NOMINAL |
| AEFD |
ACTUATOR TYPE |
SINGLE SHAFT |
| AXGY |
MOUNTING METHOD |
UNTHREADED HOLE |
| AARG |
RELIABILITY INDICATOR |
NOT ESTABLISHED |
| AFJN |
III FRAGILITY FACTOR |
MODERATELY DELICATE |
| ABMK |
III OVERALL WIDTH |
0.250 INCHES NOMINAL |
| CQCK |
ROTARY ACTUATOR TRAVEL IN ANGULAR DEG |
9000.0 NOMINAL |
| CQCC |
ELECTRICAL RESISTANCE PER SECTION |
5.0 KILOHMS SINGLE SECTION |
| ABTB |
MOUNTING HOLE DIAMETER |
0.087 INCHES MINIMUM |
| CSDL |
STANDARD TAPER CURVE PER SECTION |
A SINGLE SECTION |
| AEFK |
MAXIMUM STARTING TORQUE |
5.00 INCH-OUNCES |
| CRGD |
POWER DISSIPATION RATING PER SECTION IN WATTS |
2.0 HEAT SINK SINGLE SECTION |
| TEST |
TEST DATA DOCUMENT |
49956-373136 DRAWING (THIS IS THE BASIC GOVERNING DRAWING, SUCH AS A CONTRACTOR DRAWING, ORIGINAL EQUIPMENT MANUFACTURER DRAWING, ETC.; EXCLUDES ANY SPECIFICATION, STANDARD OR OTHER DOCUMENT THAT MAY BE REFERENCED IN A BASIC GOVERNING DRAWING) |
| CQGN |
AMBIENT TEMP IN DEG CELSIUS PER SECTION AT ZERO PERCENT RATED POWER |
200.0 SINGLE SECTION |
| ADAU |
BODY HEIGHT |
0.328 INCHES NOMINAL |
| CSDH |
AMBIENT TEMP IN DEG CELSIUS PER SECTION AT FULL RATED POWER |
130.0 SINGLE SECTION |
| CRSS |
RESISTANCE TOLERANCE PER SECTION IN PERCENT |
-5.0 TO 5.0 SINGLE SECTION |
| ABHP |
III OVERALL LENGTH |
1.312 INCHES NOMINAL |
| ABKW |
III OVERALL HEIGHT |
0.328 INCHES NOMINAL |
| AEDX |
SHAFT STYLE |
ROUND, SLOTTED |
| APXH |
TERMINAL LOCATION |
REAR END |
| ADAQ |
BODY LENGTH |
1.250 INCHES NOMINAL |
| TTQY |
TERMINAL TYPE AND QUANTITY |
3 WIRE LEAD |
| AAQL |
BODY STYLE |
RECTANGULAR W/MOUNTING HOLES/SLOTS |
| AAPN |
SECTION QUANTITY |
1 |
| CRFJ |
TEMP COEFFICIENT OF RESISTANCE PER SECTION IN PPM PER DEG CELSIUS |
-50.0 TO 50.0 SINGLE SECTION |
| ABWV |
SHAFT DIAMETER |
0.125 INCHES NOMINAL |
